Garden Driveway Paving Pavement Mold Concrete

Description

Garden Driveway Paving Pavement Mold Concrete Step Stone Path Maker Walkway Mold

DESCRIPTION

Material: PP resin

Irregular size: 35 cm x 35 cm

Applicable to:

1. Self-built houses, DIY design corridors, home roads, balconies, courtyards, gardens, vegetable plots, landscapes, swimming pools, art floors.

2. Villas, plazas, municipalities, companies, factories, hotels, resorts, cafes, clubs, spas, building designers and builders.

3. Booth to set up the set designer.

Instructions:

step 1:

Mix the cement with water according to the packing instructions. When ready for use, the concrete will be the consistency of the oatmeal and thick enough to hold the edges when cut with a shovel.

Step 2:

Fill the paver mold, plow the concrete with a shovel and make sure to fill each area.

Step 3:

Use rubber gloves to spread the concrete around the mold and fill any gaps or low points. Tap the mold by hand to remove any air bubbles.

Step 4:

Smooth the concrete according to the contour of the mold and wipe off the excess.

Step 5:

Allow the concrete to set up to five minutes and carefully remove the mold. For the next stretch, rotate the mold a quarter turn and place it next to the paver you just finished. If you are creating a curved path, tilt it slightly.

Step 6:

After allowing the concrete to solidify overnight, fill the crack with dirt and rinse off the excess. Wet the ground around the newly formed paver to help them settle.

Tips:

1. Clean the concrete garden molds for reuse and spray with garden hoses.

2. After pouring the first garden stepping stone, you can use the garden stone mold again so you don’t have to wait.

Our other same products Click

Our other hotselling products on youtube

Additional information